Powder Coating Gun Parts , PGC1 Control Module , Control Circuit Board

PGC 1 Control module

Technical data for the PGC 1 Powder Gun Control

Electrical data

Single-phase AC

Selectable voltage : 100 V, 110 V, 120 V, 200 V, 230 V or 240 V

Tolerance (at 230 V): ±10%, based on 230 V (198 V-253 V)

Voltage selection is made on the inside of the electrical unit by resoldering the tag of the transformer.

The value of the fuse for 100, 110, and 120 V is 1,0 AT and for the higher voltages is 0,5 AT.

The equipment is delivered for operation at 230V from the factory.

Frequency : 50/60 Hz

Connected load : 50 VA

Rated output voltage (to gun) : 10 V

Rated output current (to gun) : 1.2 VA

Type of protection : IP 54

Temperature range : +10o C to +40o C (+50o F to +104o F)

Specification of the external control signal :

Nominal voltage : 24 VDC

High-Voltage - On : 0.... 2,5 V

High Voltage - Off : 16.... 30 V (max. 35 V for t <100 ms)

Input current : 12 mA (typically at 24 V)

The control signal input is galvanically isolated, and protected from reversed polarity connection

over the whole input voltage range.

Pneumatic data

Main compressed air input connection thread : 1/4" B.S.P (female)

Maximum input pressure: 10 bar

Minimum input pressure: 5 bar

Maximum water vapour content of compressed air: 1.3 g/m3

Maximum oil vapour content of compressed air: 0.1 [mg/kg]

Dimensions

Width : 435 mm

Depth : 300 mm

Height : 96 mm

Weight : 12 kg

Printed circuit board - CB1      327 190